- General
-
Preguntas
0
En revisión
Hypergate Registry
I have created two 2048 x 2048 Varregions using the new 0.8 opensimulator release and have installed a hypergate on each respective region.
However, Lighthouse Point and Leviathan's Deep are still not registering as intended.
Moreso, I am unable to gridjump from my regions to anywhere else at this time.
Although the destinations are showing up on the list, the link to the target destination is not being established and prevents a jump.
I have read there are some issues regarding getting the hypergates registered from Varregions.
This is the URI of my Varregions:
http://74.170.99.194:9000
Lighthouse Point is located at coordinates 8000 x 8000
Leviathan's Deep is located at coordinates 8015 x 8015
Is there any fix being implemented for this?
Is it possible that you could register my regions in the event that I cannot accomplish this?
Thank you.
However, Lighthouse Point and Leviathan's Deep are still not registering as intended.
Moreso, I am unable to gridjump from my regions to anywhere else at this time.
Although the destinations are showing up on the list, the link to the target destination is not being established and prevents a jump.
I have read there are some issues regarding getting the hypergates registered from Varregions.
This is the URI of my Varregions:
http://74.170.99.194:9000
Lighthouse Point is located at coordinates 8000 x 8000
Leviathan's Deep is located at coordinates 8015 x 8015
Is there any fix being implemented for this?
Is it possible that you could register my regions in the event that I cannot accomplish this?
Thank you.
Servicio de atención al cliente por UserEcho
As far as the HyperGates are concerned, I have not heard of any issues with Varregions. I know of HyperGates that have been successfully registered on Varegions.
If you are unable to gridjump from your regions, then most likely the HyperGrid configuration of your region is incorrect. If the HyperGrid configuration of your region is incorrect, then it will fail our automated access test. This will prevent your HyperGate from being listed.
Please check your the HyperGrid configuration of your region. Once you are able to successfully gridjump from your regions, then use your Updater to update your HyperGates. Then within 24 - 48 hours, you shuld see your HyperGates listed.
Let us know if you have any questions.
- TheHyperGates